Ohio Governor's office seeks opportunities to grow YARS and community
Retired Col. Joe Zeis, the Senior Advisor for Aerospace and Defense for the Ohio Governor’s Office, inspects a T-pipe, used in 910th aerial spray missions, during a tour of America Makes, June 13, 2019. The T-pipe was constructed through the Maturation of Advanced Manufacturing for Low-Cost Sustainment (MAMLS) program, which is geared toward improving the efficiency of rapid part replacement for legacy and other aircraft through 3D printing, it is supported by the Air Force Research Laboratory (AFRL), the Materials and Manufacturing Directorate and the Manufacturing and Industrial Base Technology Division. (U.S. Air Force Photo/ Staff Sgt. Jeffrey Grossi)
PHOTO BY:
Staff Sgt. Jeffrey Grossi
VIRIN:
190613-F-UU934-1033.JPG
FULL SIZE:
4.75 MB
CAMERA
NIKON D850
LENS
24.0-70.0 mm f/2.8
APERTURE
35/10
SHUTTERSPEED
1/250
ISO
2500
No camera details available.
IMAGE IS PUBLIC DOMAIN
Read More
This photograph is considered public domain and has been cleared for release.
If you would like to republish please give the photographer appropriate credit.
Further, any commercial or non-commercial use of this photograph or any other
DoD image must be made in compliance with guidance found at
https://www.dimoc.mil/resources/limitations,
which pertains to intellectual property restrictions (e.g., copyright and
trademark, including the use of official emblems, insignia, names and slogans), warnings
regarding use of images of identifiable personnel, appearance of endorsement, and related matters.